How to Bind Carpet on a Stair Landing

Binding carpet on a stair landing can be a challenging task, but with the right steps, you can achieve a professional look. Here are the steps to follow:

Step 1: Measure the Landing
Measure the landing to determine the amount of carpet you will need. Measure the length and width of the landing and add a few inches to each measurement to ensure you have enough carpet.

Step 2: Cut the Carpet
Use a straight edge and a sharp utility knife to cut the carpet to the appropriate size. Make sure to cut the carpet slightly larger than the landing to ensure a tight fit.

Step 3: Secure the Carpet
Lay the carpet on the landing and make sure it is centered. Use a staple gun to secure the carpet to the landing. Start at the center of the landing and work your way out towards the edges. Make sure to pull the carpet tight as you staple it down.

Step 4: Trim the Edges
Use a straight edge and a sharp utility knife to trim the excess carpet from the edges of the landing. Make sure to leave a little bit of excess carpet to fold over the edge.

Step 5: Fold the Edges
Fold the excess carpet over the edge of the landing and use a staple gun to secure it in place. Make sure to pull the carpet tight as you staple it down.

Step 6: Finish the Edges
Use a carpet binding tape to finish the edges of the landing. Apply the tape to the edge of the carpet and fold it over the edge of the landing. Use a hot glue gun to secure the tape in place.

Step 7: Clean Up
Clean up any excess carpet or debris from the landing. Vacuum the carpet to remove any loose fibers.

By following these steps, you can successfully bind carpet on a stair landing and achieve a professional look.