| Tools and Supplies to Bind Carpet With a Carpet Binding Tool | ||||
|---|---|---|---|---|
| 1 | Carpet binding tool | |||
| 2 | Carpet binding tape | |||
| 3 | Hot glue gun | |||
| 4 | Hot glue sticks | |||
| 5 | Scissors | |||
| 6 | Measuring tape | |||
| 7 | Marker or chalk | |||
| 8 | Straight edge or ruler | |||
| 9 | Safety goggles (optional but recommended) | |||
| 10 | Dust mask (optional but recommended) | |||
Carpet binding is the process of sewing a strip of material, usually cotton or synthetic, onto the edge of a carpet to prevent fraying and give it a finished look. A carpet binding tool is a specialized sewing machine used for this purpose. Here are the steps to bind a carpet with a carpet binding tool:
Step 1: Measure the Carpet
Measure the length and width of the carpet you want to bind. Add 6 inches to each measurement to account for the binding material and seam allowances.
Step 2: Cut the Binding Material
Cut the binding material to the length and width of the carpet plus the 6 inches you added in Step 1. Fold the binding material in half lengthwise and iron it to create a crease.
Step 3: Position the Carpet
Position the carpet on a flat surface with the back side facing up. Place the binding material, folded side facing the carpet, along one edge of the carpet. Pin the binding material in place every few inches.
Step 4: Sew the Binding Material
Thread the carpet binding tool with the same color thread as the binding material. Start at one end of the binding material and sew along the crease, about 1/4 inch from the edge. Continue sewing until you reach the corner of the carpet.
Step 5: Miter the Corners
When you reach the corner of the carpet, stop sewing about 1/4 inch from the edge. Lift the binding material and fold it at a 45-degree angle to create a mitered corner. Lower the binding material and continue sewing along the next edge.
Step 6: Finish the Binding
When you reach the starting point, overlap the binding material by about 1 inch. Sew over the overlap to secure it in place. Trim the excess binding material and thread.
Step 7: Repeat on the Other Sides
Repeat Steps 3-6 on the remaining sides of the carpet.
Step 8: Trim the Excess Carpet
Once all sides are bound, trim any excess carpet along the edges to create a clean finish.
In conclusion, binding a carpet with a carpet binding tool is a simple process that can be done with a little practice. With these steps, you can create a professional-looking finish on any carpet.